Jetzt anpassen und kaufen
56,10 €
exkl. USt.
Konfigurieren
Norm

ISO 228-1:2000

Ausgabedatum: 2000 09 21

Pipe threads where pressure-tight joints are not made on the threads — Part 1: Dimensions, tolerances and designation

This part of ISO 228 specifies the requirements for thread form, dimensions, tolerances and designation for fastening pipe threads, thread sizes 1/16 to 6 inclusive. Both...
Weiterlesen
Gültig
Herausgeber:
International Organization for Standardization
Format:
Digital | 8 Seiten
Sprache:
Englisch

This part of ISO 228 specifies the requirements for thread form, dimensions, tolerances and designation for

fastening pipe threads, thread sizes 1/16 to 6 inclusive. Both internal and external threads are parallel threads,

intended for the mechanical assembly of the component parts of fittings, cocks and valves, accessories, etc.

These threads are not suitable as jointing threads where a pressure-tight joint is made on the thread. If assemblies

with such threads must be made pressure-tight, this should be effected by compressing two tightening surfaces

outside the threads, and by interposing an appropriate seal.

NOTE 1 For pipe threads where pressure-tight joints are made on the threads, see ISO 7-1.

NOTE 2 ISO 228-2 gives details of methods for verification of fastening thread dimensions and form, and recommended

gauging systems.

ISO 228-1:2000
2000 09 21
Pipe threads where pressure-tight joints are not made on the threads — Part 1: Dimensions, tolerance...
Norm
ISO 228-1:1994
1994 05 12
Pipe threads where pressure-tight joints are not made on the threads — Part 1: Dimensions, tolerance...
Norm
ISO 228-1:1982
1982 04 01
Pipe threads where pressure-tight joints are not made on the threads — Part 1: Designation, dimensio...
Norm
Norm
ÖNORM EN ISO 15874-3
Ausgabedatum : 2021 11 01
Kunststoff-Rohrleitungssysteme für die Warm- und Kaltwasserinstallation - Polypropylen (PP) - Teil 3: Formstücke (ISO 15874-3:2013 + Amd.1:2018) (konsolidierte Fassung)
Norm
ÖNORM EN ISO 15877-3
Ausgabedatum : 2021 11 01
Kunststoff-Rohrleitungssysteme für die Warm- und Kaltwasserinstallation - Chloriertes Polyvinylchlorid (PVC-C) - Teil 3: Formstücke (ISO 15877-3:2009 + Amd.1:2010) (konsolidierte Fassung)