Jetzt anpassen und kaufen
154,70 €
exkl. USt.
Konfigurieren
Norm

ISO 10360-5:2020

Ausgabedatum: 2020 03 31

Geometrical product specifications (GPS) — Acceptance and reverification tests for coordinate measuring systems (CMS) — Part 5: Coordinate measuring machines (CMMs) using single and multiple stylus contacting probing systems using discrete point and/or scanning measuring mode

This document specifies acceptance and periodic reverification tests of CMM performance with contacting probing systems and is only applicable to CMMs using: — any ty...
Weiterlesen
Gültig
Herausgeber:
International Organization for Standardization
Format:
Digital | 42 Seiten
Sprache:
Englisch

This document specifies acceptance and periodic reverification tests of CMM performance with contacting probing systems and is only applicable to CMMs using:

— any type of contacting probing system; and

— spherical or hemispherical stylus tip(s).

NOTE CMM probing performance tests are specified by the maximum permissible errors (MPEs), due to the impracticality of isolating the performance of the probing system from that of the CMM, even on a small artefact such as a test sphere.

This document applies to CMMs supplied with any of the following:

a) single-stylus probing systems;

b) multi-stylus probing systems with fixed multiple styli attached to a single probe (e.g. "star" stylus);

c) multiple probing systems such as those with a stylus for each of their probes;

d) systems with articulating probing systems;

e) stylus and probe changing systems;

f) manual (non-driven) and automated CMMs;

g) installations including a scanning probe, capable of being used in a scanning mode.

This document is not applicable to non-contacting probing systems, which require different testing procedures.

The term ?combined CMM and multi-stylus probing system size error' has been shortened to ?multi-stylus size error' for convenience. This applies in similar cases.

If it is desirable to isolate the probing system performance as far as is practical, the influence of the CMM can be minimized but not eliminated. See Annex C for more information.

ISO 10360-5:2020
2020 03 31
Geometrical product specifications (GPS) — Acceptance and reverification tests for coordinate measur...
Norm
ISO 10360-5:2010
2010 09 10
Geometrical product specifications (GPS) — Acceptance and reverification tests for coordinate measur...
Norm
ISO/PAS 12868:2009
2009 11 27
Geometrical product specification (GPS) — Coordinate measuring machines (CMM): Testing the performan...
Technische Regel
ISO 10360-4:2000/Cor 1:2002
2002 11 20
Geometrical Product Specifications (GPS) — Acceptance and reverification tests for coordinate measur...
Norm
ISO 10360-5:2000
2000 12 21
Geometrical Product Specifications (GPS) — Acceptance and reverification tests for coordinate measu...
Norm
ISO 10360-4:2000
2000 03 30
Geometrical Product Specifications (GPS) — Acceptance and reverification tests for coordinate measur...
Norm
Historie aufklappen